ATH-Heinl Cross Lift 35 OG User Manual page 84

3. Hydraulic oil
Fill up the hydraulic oil to the mark on the dipstick.
Only use the oils specified in the technical data for this purpose.
Main Hub
B1 = Master cylinder (P1)
B2 = Slave cylinder(P2)
C1 = Slave cylinder (P1)
C2 = Slave cylinder (P2)
When routing the hydraulic hoses, make sure that the hose is clear of any
moving part. Make sure to keep the hoses and fittings clean from dust.
The corresponding circuit diagram can be found in Appendix 6.3 of these operating instructions.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-11
Wheel-free jack
A1 = Master cylinder (P1)
A2 = Slave cylinder (P2)
Manufacturer ATH-Heinl GmbH & CO.KG
- 23 -