Reaction To Cpu Stop; Address Space - Siemens SIMATIC ET 200SP Manual

Configuring/address space

4.2 Reaction to CPU STOP

4.2 Reaction to CPU STOP
Reaction to CPU STOP
You set the response of the technology module to CPU STOP for each channel in the basic
parameters of the device configuration.
Table 4- 1
Basic parameters
Continue operation
Output substitute value
Keep last value
4.3

Address space

Address space of the technology module
Table 4- 2
Range
Table 4- 3
Range
28
Response of the technology module to CPU STOP depending on parameter assignment
Reaction to CPU STOP
The technology module remains fully functional. Incoming count
pulses are processed or the position value is read in. The digital
outputs continue to switch according to the parameter assignment.
The technology module outputs the configured substitute values at
the digital outputs until the next CPU STOP-RUN transition.
The technology module is returned to its startup state after a
STOP-RUN transition: The counter value is set to the Start value
(with incremental encoders or pulse encoders) and the digital
outputs switch according to the parameter assignment.
The technology module outputs the values at the digital outputs
that were valid when the transition to STOP took place until the
next CPU STOP-RUN transition.
The technology module is returned to its startup state after a
STOP-RUN transition: The counter value is set to the Start value
(with incremental encoders or pulse encoders) and the digital
outputs switch according to the parameter assignment.
Range of the input addresses and output addresses of the TM PosInput 1
Inputs
16 bytes
Range of the input and output addresses of the TM PosInput 1 in the "Position input for
Motion Control" mode
Inputs
16 bytes
Outputs
12 bytes
Outputs
4 bytes
Technology module TM PosInput 1 (6ES7138-6BA00-0BA0)
Manual, 02/2014, A5E33015755-AA