Omron 3G8F5-DRM21 Operation Manual page 60

Controlling the CompoBus/D Configurator
46
2. When using Windows 95/98 or Windows NT 4.0, select the folder in which
the CompoBus/D Configurator was installed and then select the "Compo-
Bus_D Configurator."
When using Windows NT 3.51, double-click on the "CompoBus_D Configu-
rator" icon.
The Configurator will start as shown in the following diagram. No devices will
be displayed at startup.
Note The board will operate normally if the Configurator has the following
settings when "Online" is selected from the "File" menu.
CompoBus/D Cable connected: Online normally
CompoBus/D Cable disconnected: Bus off
The status of the CompoBus/D Configurator is displayed at the very
bottom of the window. When the Configurator is online, "on-line" will
be displayed in blue. When a bus off occurs, "Busoff" will be displayed
in red.
3. After verifying that the Configurator is operating properly, select "Exit from
CompoBus/D Configurator" from the "File" menu to exit the program.
Note Always switch the Configurator to offline status before exiting.
Section 2-6