Omron 3G8F5-DRM21 Operation Manual page 57

CompoBus/D Configurator Installation
10. When the files in disk 1 have been loaded, you will be prompted to insert
disk 2. Insert disk 2 into the floppy disk drive and click on "OK."
11. When the files in disk 2 have been loaded, you will be prompted to insert
disk 3. Insert disk 3 into the floppy disk drive and click on "OK."
12. A program group folder will be created automatically when the CompoBus/D
Configurator installation has been completed.
13. A popup window will be displayed asking whether you want to setup the ISA
Board or PCMCIA Card to be used with the Configurator. Click on "Yes."
If you click on "No," the installation program will end without performing the
setup for the ISA Board or PCMCIA Card.
Note The setup for the ISA Board or PCMCIA Card can be performed later by running
the "3G8xx-DRM21 Configuration" program that is in the same program folder
as the CompoBus/D Configurator.
14. The setup program for the ISA Board or PCMCIA Card starts when "Yes" is
selected in step 13 or the "3G8xx-DRM21 Configuration" program is run
from the program folder.
There is already a card driver called Driver250 registered, so click on "Edit."
(The "New" selection is used to add a driver for the ISA Board or PCMCIA
Card and the "Remove" selection is used to delete the selected driver.)
Note The card name registered here will be used on the CompoBus/D
Configurator to access the ISA Board or PCMCIA Card. Register a
name for each ISA Board and PCMCIA Card.
15. Set the I/O port address, memory address, and interrupt (IRQ) for the ISA
Board or PCMCIA Card being used with the Configurator.
Section 2-4
43