Operations; Initial Operation; Screen Description; 3-2.1. Main Screen - Njoy Garun Series User Manual

3

Operations

3.1. Initial operation

Step 1. Before operation, make sure that the two strings of batteries
are connected correctly in order
of the battery pack is at "ON" position (only in case of external battery packs
presence).
Step 2. Press the POWER button to set up the power supply for the
UPS. UPS will enter to power on mode. After initialization, UPS will enter to
"No Output mode".
ON/OFF UPS
Battery test
Control
Mute all
ON/OFF charger
Measure 1
Measure Measure 2
Measure 3
Main
Setting General
Advance
Save setting
Basic info
Rated info
Info
Parameter info
Data Log
18
of "+,GND,-" terminals and the breaker
Electrical
Battery
Miscellaneous
User mode
Password: 0000
Basic 1
Maintaner mode
Password: ****
Basic 2
SYS parameter
User
Install info
Maintainer
VOL CALLI
CURR CALLI
Initial
Electrical Parameters
Battery Calibration
Miscellaneous
UPS self-test

3.2. Screen description

After initialization, the LCD will display main screen.
There are five sub-menus: Control, measure, setting, information and data log.
Touch any sub-menu icon to enter into the sub-screen.
NOTE!
Maintainer Menu is detailed only in 'Addendum to User manual'. If you need
assistance or have any warning or fault codes on your UPS screen, please contact
the technician that installed the UPS.
DO NOT attempt to modify any settings of the UPS unless you are a trained
technician. This UPS carries lethal voltages. All repairs and service must be
performed by authorized personnel only.
3.2.1. Main screen
Upon powering on, the LCD will start initialization process that takes a few
seconds.
After initialization, the main screen will display as shown below. On the
bottom, there are five icons to represent five sub-menus: CONTROL,
MEASURE, SETTING, INFO, DATALOG.
Data log
EEPROM
Touch
Main screen
19