Troubleshooting; Machine Trouble - FujiFilm Apeos C7070 Reference Manual

2.7

Troubleshooting

If you have an EP-BB MFD management service contract, the machine automatically sends an
inspection or repair request to our Customer Support Center as needed. A service representative
visits you in response to the notification as required.

Machine Trouble

Symptom
The machine is not
powered on.
The display is blank.
The printer makes an odd
noise.
Condensation has formed
in the machine.
The machine does not
switch to the Power Saver
Mode.
The power cord may have been unplugged or may not be firmly
plugged in.
Switch the machine power off, and then reconnect the power cord to
the power outlet and the machine. Then switch the machine power on.
Connect the machine to a power outlet that supplies the proper rated
voltage or current.
The machine may be in the Power Saver Mode. Press the Power button
on the Control Panel to exit the Power Saver Mode.
Install the printer on a level, sturdy surface.
Push the trays firmly into the machine.
There may be a foreign object inside the machine.
Switch the machine power off, and then remove the foreign object
inside the machine. If the object cannot be removed without
dismantling the machine, contact your local representative.
On the control panel, set the Sleep Mode trigger time to more than 60
minutes, and let the machine stand with its power on for 60 minutes.
Before using the machine, make sure that no water droplets remain
inside the machine (rollers, metal parts, etc.). If condensation occurs
frequently, keep the machine power switched on by selecting
[Device]> [System Settings] > [System Clock / Timers] > [Warmer
Mode] > [On] on the Control Panel. This may remedy the
condensation.
The machine does not enter the Low Power Mode or the Sleep Mode in
the following cases to inform users on what is happening to the
machine and provide its performance.
When the user is operating the Control Panel

When a message indicating to replace any one of the consumables is

displayed
When the machine requires user operation for paper jams or open

covers
When an error occurs due to machine failure

When the machine is executing the condensation prevention

processing as the [Warmer Mode] is set to [On].
Cause/Remedy
2.7 Troubleshooting
>
33