Specifications; Troubleshooting - FujiFilm instax mini Link 2 User Manual

Specifications

Recording method 3-color exposure with OLED
Film used FUJIFILM INSTAX MINI Instant Film (sold
separately)
Image size 2.4 in x 1.8 in/62 mm × 46 mm
Exposure pixel 800 × 600 dots
count
Exposure resolution 12.5 dots/mm (318 dpi, 80 μm dot pitch)
Exposure gradation RGB gradation of 256 colors
Interface Bluetooth Ver. 4.2 (BLE)
Printable image JPEG, PNG, HEIF, DNG
format
Print transmission Approximately 15 seconds for
time transmission and to start printing
* Print development time approximately
90 seconds
Possible number of Approximately 100 (from full charge;
printed images number of prints depends on the usage
conditions.)
Power supply Lithium ion battery (internal type: not
removable)
Charging time Approximately 80 to 120 minutes
(depending upon environment
temperature at time of charging)
Power consumption Approximately 3 W
Operating Temperature: +41°F to +104°F (+5 °C to
environment +40°C)
Humidity: 20% to 80% (no condensation)
Main unit 3.6 in × 1.4 in × 4.9 in (91.9 mm × 36.4
dimensions mm × 124.8 mm) excluding projecting
parts
Main unit weight Approximately 0.46 lbs (210 g) excluding
film pack
Supplied accessory Micro USB cable (BOD700)
Length: 11.8 in (30 cm)
*The above specifications are subject to change.
12

Troubleshooting

Please check the following items before considering a problem to
be a malfunction. If the problem persists even after taking action,
please contact the Fujifilm service center for repair in your country
or visit the website below.
https://instax.com/mini_link_2/en/support/faq/
If the following problem occurs���
Problem Possible causes and solutions
I cannot turn on • The battery may not be charged. Please
the printer. charge the printer.
• You did not press the Power button long
enough. Press and hold the Power button
for approximately 1 second.
The battery loses If you use the printer in a very cold
its charge environment, the battery will drain quickly.
quickly. Please keep the printer warm before
printing.
The printer The battery level may be low. Please charge
turned off during the printer.
use.
Charging does Make sure that the USB power adapter plug
not start. is properly connected to the power outlet.
It takes too long At low temperatures, charging may take
to charge. some time.
Charging does Charge the battery in a temperature range
not start or of 41°F to 104°F (5°C to 40°C). If you cannot
prematurely charge the printer in this range, contact
stops. your FUJIFILM dealer or support center.
The printer does • There may be a temporary malfunction.
not work Please press the reset button. If it still
properly. does not work properly, please contact
our repair service center for repair.
• The battery may not be charged. Please
charge the printer.
The film pack • Please use FUJIFILM INSTAX MINI instant
does not load or print film only (INSTAX SQUARE or INSTAX
does not load WIDE instant print film cannot be used).
smoothly. • Align the yellow mark on the film pack
with the printer alignment mark (yellow)
and load it.
The film does not • The film may be misaligned due to shock
unload. such as vibration or dropping. Please load
a new film pack.
• If the film is jammed, turn the printer off
and turn it on again. If the problem
persists, remove the jammed film and
then load a new film pack.
Some or all of the Do not open the film door until the film is
finished prints used up. If the film door is opened with film
are white. remaining, the film is exposed and the
exposed area becomes white.