Table of Contents
Advertisement
Specifications
Recording method
3-color exposure with OLED
Film used
FUJIFILM instax mini Instant Film (sold
separately)
Image size
62 mm × 46 mm
Exposure pixel
800 × 600 dots
count
Exposure resolution
12.5 dots/mm (318 dpi, 80 μm dot pitch)
Exposure gradation
RGB gradation of 256 colors
Interface
Bluetooth Ver. 4.2 (BLE)
Printable image
JPEG, PNG, HEIF, DNG
format
Printing time
Approximately 15 sec.
Possible number of
Approximately 100 (from full charge;
printed images
number of prints depends on the usage
conditions.)
Power supply
Lithium ion battery (internal type: not
removable)
Charging time
Approximately 80 to 120 minutes
(depending upon environment
temperature at time of charging)
Power consumption
Approximately 3 W
Operating
Temperature: +5°C to +40°C
environment
Humidity: 20% to 80% (no condensation)
Main unit
91.9 mm × 36.4 mm × 124.8 mm
dimensions
(excluding projecting parts)
Main unit mass
210 g (excluding film pack)
Supplied accessory
Micro USB cable (BOD700-200, Length:
30 cm)
*The above specifications are subject to change for performance
improvement.
12
Troubleshooting
Please check the following items before considering a problem to
be a malfunction. If the problem persists even after taking action,
please contact the FUJIFILM service center for repair in your
country or visit the website below.
FUJIFILM website: http://www.fujifilm.com/
If the following problem occurs���
Problem
Possible causes and solutions
I cannot turn on
• The battery may not be charged. Please
the printer.
charge the printer.
• You did not press the Power button for
long enough. Press and hold the Power
button for approximately 1 second.
The battery
If you use the printer in a very cold
loses its charge
environment, the battery will drain quickly.
quickly.
Please keep the printer warm before
printing.
The power cut
The battery level may be low. Please charge
off during use.
the printer.
Charging does
Make sure that the USB power adapter plug
not start.
is properly connected to the power outlet.
The printer takes
At low temperatures, charging may take
too long to
longer.
charge.
Charging stops
Charge the battery in a temperature range of
during charging.
+5 °C to +40 °C. If you cannot charge the
printer in this range, contact your FUJIFILM
dealer or support center.
The printer does
• There may be a temporary malfunction.
not function
Please press the reset button. If the printer
normally.
still does not function normally, please
contact our repair service center for repair.
• The battery may not be charged. Please
charge the printer.
The film pack
• Please use FUJIFILM instax mini Instant
does not load or
Film (other films cannot be used).
does not load
• Align the yellow mark on the film pack
correctly.
with the yellow alignment marker on the
printer body, once aligned load the film
into the printer.
The film does
• The film may be misaligned due to an
not unload.
impact such as vibration or dropping.
Please load a new film pack.
• If the film is jammed, turn the printer off
and turn it on again. If the problem
persists, remove the jammed film and
then load a new film pack.
Some or all of
Do not open the film door until the film has
the finished
been used up. If the film door is opened with
prints are white.
film remaining, the film will be exposed and
become white.
The print is
• Do not shake, bend, fold or hold the print
uneven.
immediately after it is printed.
• Do not obstruct the film ejection slot.
Advertisement
Table of Contents
