Sequencer - Roland KIWI-3P Manual

Sequencer

www.kiwitechnics.com
The JX-3P Upgrade contains a
polyphonic sequencer that has the
capacity of 124 step automatic
playing. Up to 6 notes can be
played at a time so writing a chord
is possible.
Sequencer Write Button
This button is used for ARP CLOCK
DIVIDE edit in the Kiwi-3P Matrix
and is not used for the sequencer
Sequencer Tie Button
This button is used for SEQ CLOCK
DIVIDE edit in the Kiwi-3P Matrix.
Press this button and edit the Clock
Divide using the SENS Edit slider.
Press again to exit Seq Clock edit
mode.
This button is also
Sequence Erase. To ERASE a Seq
long press this button.
Sequencer Rest Button
This button is used for SEQ LOAD
and SEQ EDIT in the Kiwi-3P Matrix.
To Load a Sequence into the Edit
Buffer press this button followed by
a Tone button 1-8. Note that the
TONE buttons are the JX-3P buttons
9-16.
To Edit a Sequence Long press this
button to start Edit mode.
Note - if more than 6 notes are used
in one step only the last 6 notes will
play.
Rate Knob
This controls the speed of the
Master Clock if the clock source is
selected as internal using parameter
control GA:2:1. If the clock source is
set to MIDI source this control will
have no effect. Also if a clock
source is plugged into the external
socket labeled "Seq Trigger In" on
the rear of the 3P this will override
the internal clock and this control.
If the 3P has been configured to
send midi Clocks then the Rate
used for
control will set the speed of these.
Note - if anything is plugged into the
External Input labeled "Seq Trigger
In" the internal Clock will
is a hardware function of the 3P .
Start/Stop Button
This button is used to start or stop
the sequencer playing. Each time
you press this button the sequencer
will start or stop.
source is midi or external the
sequence will not begin playing until
the first clock is received.
Kiwi-3P Matrix Upgrade User Manual v1.2
17
stop. This
Note - If the clock