Mount The Transmitter - Emerson Rosemount FOUNDATION 848T Quick Start Manual

December 2021
2

Mount the transmitter

2.1 Mount to a DIN rail without an enclosure
To mount the transmitter to a DIN rail without an enclosure, follow these
steps:
Procedure
1. Pull up the DIN rail mounting clip located on the top back side of the
transmitter.
2. Hinge the DIN rail into the slots on the bottom of the transmitter.
3. Tilt the transmitter and place onto the DIN rail. Release the mounting
clip. The transmitter should be securely fastened to the DIN rail.
Figure 2-1: Mount the transmitter to a DIN rail
2.2 Mount to a panel from an aluminum junction box
Prerequisites
Use four 1/4-20 x 1.25-in. screws.
Procedure
Mount the transmitter to a panel from inside the junction box using one of
the following dimension drawings.
Quick Start Guide
A. Rosemount 848T without installed enclosure
B. DIN rail mounting clip
C. DIN rail
Quick Start Guide
7