Download Print this page

Emerson Rosemount FOUNDATION 848T Quick Start Manual page 5

Fieldbus high density temperature transmitter
Hide thumbs Also See for Rosemount FOUNDATION 848T:

Advertisement

December 2021
WARNING
Electrical shock could cause death or serious injury.
If the sensor is installed in a high-voltage environment and a fault or
installation error occurs, high voltage may be present on transmitter leads
and terminals.
Use extreme caution when making contact with the leads and terminals.
CAUTION
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following conditions:
This device may not cause harmful interference.
This device must accept any interference received, including
interference that may cause undesired operation.
This device must be installed to ensure a minimum antenna separation
distance of 7.9 in. (20 cm) from all persons.
NOTICE
Battery hazards remain when cells are discharged.
The power module may be replaced in a hazardous area. The power module
has surface resistivity greater than one gigaohm and must be properly
installed in the wireless device enclosure. Care must be taken during
transportation to and from the point of installation to prevent electrostatic
charge build-up.
Shipping considerations for wireless products.
The unit was shipped to you without the power module installed.
Remove the power module prior to any re-shipping.
Each power module contains two "C" size primary lithium batteries.
Primary lithium batteries are regulated in transportation by the U. S.
Department of Transportation, and are also covered by IATA
(International Air Transport Association), ICAO (International Civil
Aviation Organization), and ARD (European Ground Transportation of
Dangerous Goods). It is the responsibility of the shipper to ensure
compliance with these or any other local requirements. Consult current
regulations and requirements before shipping.
Quick Start Guide
Quick Start Guide
5

Advertisement

loading