Advertisement
2-part Track-Mounted Floor Lock (255-mm Gauge NMI System)
FRONT OF
VEHICLE
HEAD
END
HEAD END
FLOOR LOCK
1. Removal of Head End and Foot End Lock Assemblies
• On each locking assembly, undo the conical locking devices then retract the
plunger and pull up release handle and blade of both locking devices.
• Remove lock assemblies.
• The small positional guide plates at the head end and foot end must remain fitted
to the floor of the vehicle.
FERNO/MAN/1121/162-R10/UK
VEHICLE OFFSIDE WALL
SLOTS FOR ADJUSTMENT
OF LOCKING DEVICES
TROLLEY
PERMANENT POSITIONAL
GUIDE PLATE
2. Installation of Head End Lock Assembly
• As shown in diagram A (left), ensure handle and
blade of locking devices are in the fully open (up)
position.
• Adjacent to the positional guide plate fitted to the
vehicle floor between the tracking at the head
end, locate the pegs on the underside of the lock
assembly in the tracking.
• As shown in diagrams B & C, push blade of each
locking mechanism down by hand until it stops.
• Push handle of each locking mechanism fully
down (diagram D) until the integral plunger locks
into place (diagram E).
• Re-tighten the conical locking devices, test for
security & safety.
3. Installation of Foot End Lock Assembly
Install foot end lock assembly in exactly the
same way as above adjacent to the positional
guide plate at the foot end.
FOOT
END
255
GAUGE
TRACKING
PERMANENT
FOOT END
POSITIONAL
FLOOR LOCK
GUIDE PLATE
Page 8
Advertisement
