Table of Contents
Advertisement
LUNA2000-(5-30)-NHS0
User Manual
Category
Battery system
indicator
6.3 Battery Commissioning
6.3.1 Device Commissioning (FusionSolar App)
(Recommended)
For details about how to use the site deployment wizard, see
Energy Storage System Setting App
scan the QR code to download the quick guide.
Figure 6-1 Residential PV energy storage system setting app guide
After the construction is complete, check the installation by referring to the
Checklist for the Construction of Residential PV Energy Storage
Issue 06 (2022-03-01)
Status (Blinking at Long
Intervals: On for 1s and then
Off for 1s; Blinking at Short
Intervals: On for 0.2s and
then Off for 0.2s)
Green
Steady red
NO TE
● You can set parameters on the FusionSolar app (recommended) or SmartLogger WebUI
(not recommended) as required.
● Install the FusionSolar app (5.7.001 or later).
● Mobile phone operating system: Android 5.0, iOS 11.0, or later versions are supported.
You are recommended to use mobile phones of Android 8.0 to 10.0 or iOS 13.0 to 14.8.
Use mobile phones that support web browsers and can access the Internet.
NO TE
● During system deployment, if the communications cables Enable+/Enable– are correctly
connected, the SUN2000 enables the battery and the indicator is on. Do not press the
black start button to enable the battery. Otherwise, the communications cable
connection between the SUN2000 and the battery cannot be verified.
● If no PV modules are installed or the system has not detected sunlight for at least 24
hours, the minimum end of discharge SOC is 15%.
Copyright © Huawei Technologies Co., Ltd.
Description
N/A
Battery level. Each bar indicates 10%.
The first three bars indicate the number
of faulty battery expansion modules.
Guide. During the FusionSolar app upgrade,
6 System Commissioning
Residential PV
System.
64
Advertisement
Table of Contents
