Table of Contents
Advertisement
LUNA2000-(5-30)-NHS0
User Manual
5.2.3 Connecting Internal Signal Cables
Connecting Signal Cables Between the Power Control Module and Battery
Expansion Modules
Figure 5-4 Securing With Clips
Issue 06 (2022-03-01)
NO TE
● The protective housing of the communications terminal delivered with the device can be
fastened with clips or screws based on the actual diagram.
● Connect the communications terminals of the power control module and battery
expansion modules in sequence and secure them using cable clips. Install the internal
signal cables described in this section using the three signal cables with a diameter of 5
mm and rubber plugs delivered with the DCDC. Do not use signal cables with a
diameter of 7 mm. Do not install a cable with a diameter of 5 mm into a Ф7 mm
rubber plug, the 7 mm hole is used to connect to an inverter or cascaded battery.
Copyright © Huawei Technologies Co., Ltd.
5 Electrical Connection
46
Advertisement
Table of Contents
