Kodak SRP 30 Operator's Manual page 257

Operator's Guide
Daily Weekly Monthly
WARNING:
8-4
When Maintenance jobs to be performed by the customer
required
Clean air filters
x
– Lamp house
– CCD fan
– Below cutter units
– Door to print engine
– Paper processor: Right side wall, dryer, and AC
supply
Change scan lamp (service life approx. 300 hr)
x
x Change chemical filters
x Clean processing racks
Clean dryer rack
x
Clean paper outlet PO:
x
– Clean / replace air filter
– Clean slide plate with feed chute
– Clean rubber transport belts
Remove dust from lens
x
x Replace all air filters with the Annual Air Filter Kit
x Change back printer ink ribbon
Empty effluent tanks
x
Observe the safety precautions on all equipment labels and in
the Regulatory and Safety section of this manual.
Do not clean while power is applied to the paper processor
drive.
To prevent injury when working in the printer area, avoid
contact with the toothed belts and any sharp corners or edges.
KODAK PROFESSIONAL SRP 30 Laser Printer