11. CLEANING
Tip
Your RIKA dealer will be happy to advise you and can offer you a
maintenance contract�
Depending on pellet consumption, a message prompting cleaning of
the stove appears on the display in regular intervals� This message
can be acknowledged on the Touch Display, while continuing
operation� Perform a cleaning cycle at the next opportunity�
Subsequently, reset the counter in the SETTINGS menu / RESETS
submenu, as per operating instructions of TOUCH DISPLAY�
Tip
The message will only stop reappearing once you have reset the
feed volume in the SETTINGS / RESETS menu�
Note
Your stove must be switched off and cooled before any cleaning
work is performed� Only work on the unit when the mains plug has
been disconnected�
Cleaning the convection air openings
Vacuum clean any dust deposits from the convection air openings
at regular intervals�
The stove should be cleaned thoroughly prior to the start of the
heating season to prevent excess odour�
Note
To prevent your stove from overheating of the internal components,
do never cover the convection fins!
Combustion air - intake
Note
Only when the stove is cold! You could vacuum out embers – FIRE
RISK!
If necessary, please also clean the air intake with a hoover�
Cleaning the pellet container
Do not refill the completely empty container immediately; remove
the residues (dust, chippings etc�) from the empty container� The unit
must be disconnected from the mains!
Cleaning the flue gas channels
(annually)
Remove the flue pipes� Inspect and clean chimney connection� Brush
off any soot and dust deposits in the fire and in the flue pipes and
vacuum�
Note
Accumulated fly ash in the flue gas channels may impair the
performance of the stove and pose a safety risk�
Check seals
(annually)
Check the condition of the seals at least once a year� Repair or
replace seals depending on condition�
Note
Only intact seals ensure your stove works perfectly!
Tip
You will find the seals and sealing kit in the spare part overview�
Check bearings
(annually)
All built in bearings (pellet screw, turning grid) should be checked�
Clean or replace bearings depending on condition�