TROUBLESHOOTING
Before resorting to maintenance service, please kindly check by yourself with the
following chart.
Symptom
•
The adapter is not connected to the
unit securely or is not connected to the
No Power
power supply.
•
The unit is turned off.
Picture
There is no
picture dis-
•
The TV is not connected to this unit
played on the
securely with the AV cable.
connected
TV.
•
The volume is set to the lowest level.
•
The sound is switched off.
Sound
•
The disc is in fast forward/reverse
There is no
playback.
sound.
•
The sound is output through the con-
nected earphone.
•
This disc is placed in the disc tray in a
Unable to
wrong way.
play a disc
•
The unit isn't compatible with the disc.
•
The disc is dirty.
The player
breaks down
when a USB
•
The connected USB drive or the
drive or
memory card is probably not a certified
memory card
one.
is inserted
into the
player.
•
There is no battery in the remote con-
trol.
The remote
•
The battery is out of charge.
control does
•
The remote control isn't pointed to the
not
remote sensor.
function.
•
The remote control is out of its
operating area.
•
The unit is shut down.
Cause(s)
ENG - 72
Remedy
•
Connect the adapter to the DC input jack
securely and then plug the adapter into
an AC outlet (for AC/DC adapter) or the
cigarette lighter socket of a car (for ciga-
rette lighter adapter).
•
Make sure that the unit is turned on.
•
Connect the AV OUT jack of this unit and
the AV IN jack of a TV securely with an
AV cable.
•
Turn up the volume.
•
Press [MUTE] to switch on the sound.
•
Press [PLAY] to resume the normal play-
back.
•
Pull out the earphone and the sound will
output through the built-in speakers.
•
Check that the disc is placed in the disc
tray with its label side upwards.
•
Clean the disc.
•
The player cannot play any uncertified
USB drive and memory card. In case
the player breaks down, turn it off, dis-
connect the power cord from the AC
outlet and unplug the USB drive or/and
the memory card from the player. Then,
power on the player again. The player
will resume the normal status.
•
Install a CR2025 lithium battery in it.
•
Replace the battery with a new one.
•
Make sure that the remote control is
pointed to the remote control sensor.
•
Make sure the remote control is within
the operating area.
•
Switch off the unit and disconnect it from
the AC outlet. Then power on the unit
again.