Kenwood HM-582MD Instruction Manual page 28

Contents
28
Tuning a non-preset radio station (Auto tuning, Manual tuning)
1 Press the TUNER/BAND key to select "FM" or
"AM".
2 Press the PGM/CHARAC. key to select auto tun-
ing or manual tuning.
Normally, use the "AUTO" (Auto tuning) mode.
/CHARAC.
AUTO/MONO
3 Press the 1,¡ key to receive a station.
Auto tuning mode :
Each press receives a new station.
Manual tuning mode :
Press repeatedly until the desired station is re-
ceived.
1
To decrease
frequency
One-by-one presetting (manual preset)
1 Perform the procedure in "Tuning a non-preset
radio station" to receive the station you want to
preset.
2 Press the ENTER key during reception.
ENTER
3 Select the desired preset number between 1 and
40 using the numeric keys on the remote control
unit.
4 Press the ENTER key.
ENTER
TUNER/BAND
PGM
TUNING
1
To increase
frequency
÷ Use the manual tuning mode when reception is noisy due to
weak reception. (In the manual mode, stereo broadcasts are
received in monaural.)
Each press of the key alternates these tuning
modes.
"AUTO"
AU TO
STEREO
"MANUAL"
MAN UAL
The preset operation is canceled when no key has been
pressed for more than 20 seconds during operation.
FM P--
MEMORY
90 00MHz
÷ Repeat steps 1~4 to preset other stations.
÷ If several stations are preset under the same number,
the previous memory is replaced with the latest
memory contents.
FM P03
MEMORY
90.00MHz
Receiving broadcast station
TONE
A.P.S.
12:30PM
TONE
A.P.S.
12:30PM
Blinks
Lights