Bartscher 700 Series Instructions For Installation, Use And Maintenance Manual page 20

The pilot burner lights off after
loosening the igniter knob
The pilot burner stays on but the main
burner does not light on
Slow and/or inadequate heating
No heating
No indicator light
Slow and/or inadequate heating
 The braising pan is universal equipment: it is suitable for roasting, cooking and grilling meat,
fish, vegetables, eggs, farinaceous food, and for cooking soups, sauces and risottos.
 ATTENTION: The appliance cannot be used as a fryer.
 ATTENTION: The cooking vat of the appliance must not be cooled down hard (i.e. cooling it down
by ice or cold water); otherwise there is a danger of cracking the cooking vat itself.
of the appliance;
- Switch on the main burner by turning the knob to
 Check that the flame of the pilot burner laps the
thermocouple; if this is not the case, adjust the pilot
burner through the regulating screw on the valve
 Press the gas knob in its correct position
 Change the thermocouple
 Check if the valve magnetic group is rusted
 Check the gas valve
 Check that gas inlet pressure is the same as that shown in
table BURNER FEATURES
 Check that the gas nozzles are not blocked
 Check that the burner holes are not blocked
 Check that the gas pipe is not blocked
 Check that the nozzles installed are in accordance to
table BURNER FEATURES
 Check the gas valve
 Check that gas inlet pressure is the same as that shown in
table BURNER FEATURES
 Check that the nozzles installed are in accordance to
table BURNER FEATURES
 Check the gas valve
 Check the power supply
 Check the condition of the heating element
 Check the thermostat
 Check the power supply
 Check the light bulb
 Check the setting of the thermostat
 Check the condition of the heating elements
 Check the quantity of food to be cooked
INSTRUCTIONS FOR USE
Gas Bratt Pan
In order to switch on the braising pan burner, proceed in the following
way:
- Turn the knob (1) from the off position
;
- Press down the button;
- Press the piezoelectric lighter button (2)
- Keep the knob pressed down until the thermocouple heats up,
keeping the pilot on; this can be checked through the slit on the front
202/208
 to the ignition position
to light the pilot burner;
;