Table of Contents
Advertisement
Configuring a
Program Shift
Thermo Fisher Scientific
Figure 3–11. Reset Sample 2 screen
2. In the Reset Sample 2 screen, press the "A" button to begin a second
primary sample run. The second primary sample run will begin
immediately after pressing the "A" button. The PDM3700 unit will
not perform another 35-minute warm-up period before beginning the
second primary sample run, and the Second Sample screen will display.
Note After 30 seconds of inactivity in the Reset Sample 2 screen, the
PDM3700 will automatically display the First Sample Screen #1. ▲
When in the Program Shift screen
sample run parameters, including identifying the mine information and
setting up the sample start time, duration and type.
When in the PDM - COM1 screen, select the "Program Shift" button to
display the Program Shift screen. These values will be stored in the
PDM3700's data storage buffer, and will display on the "Dust Data Card"
that can be downloaded at the end of the sample run.
Figure 3–12. Program Shift screen
Using the WinPDM Software
Configuring a Program Shift
(Figure
3–12), you can set up your
PDM3700 Instruction Manual
3-11
Advertisement
Table of Contents
