Sony MZ-N920 Operating Instructions Manual page 94

Machine Translated by Google
Q2: How to combine separated songs and groups into one?
A2: In advance, set the group settings after connecting the songs and groups you want to put together next to each other.
is. For
details, see "Changing the song order (move)" (page 53) and "Rearranging the order of groups ( group
move)" (page 54).
Q3: How is the group name recorded?
A3: When recording using the group function, the group information is automatically recorded in the recording
area of the disc name as the "disc name". Specifically, the following character string is written.
Recording area of disk name
Example)
one two three
1 Disc name: "Favorites" Group
name from 22nd to 4th song: "Rock" Group name
from 36th to 9th song: "Pops"
If the MD set as a group is read by a device that does not support the group function, the above character string
will be displayed as the "disk name" as it is. Normally, this character string is not displayed on this unit, but if you
press the GROUP button ( + or – button on the remote control) for 2 seconds or longer while editing the disk name,
this character string can be displayed. You can edit the group name directly.
Q4: The new group is not recorded, why can't I set a new group ?
why?
A4: It may be because the total number of input characters on the entire disk has exceeded the limit (system control).
about).
As shown in A3, group information is done using the disk name area. The disc name and song name are
recorded in the same area, and the maximum number of characters is approximately 1700 characters in total for
the disc name (including group information) and song name. If this number of characters is exceeded, no new
group will be created when recording in group mode. Also, when I try to set a group, I cannot.
94