Image DE 30 Instruction Manual page 54

TROUBLE SHOOTING
9. Dryer is cycling on hi – limit thermostat (GAS MODELS and ELECTRIC MODELS
ONLY).
1) Blower (impeller / fan) motor rotation direction incorrect.
2) Insufficient make – up air.
3) Restriction in exhaust system.
a. Undersized exhaust ducting.
4) Lint screen needs cleaning.
5) Failed hi – limit thermostat.
6) Failed oven contractor / relay (for ELECTRIC MODELS ONLY).
10. Condensation on main door glass.
1) Too long, undersized, or improperly installed duct work.
2) Dryer connected to common exhaust duct with another dryer, and no back draft damper
was installed in customer – famished duct work.
3) Location furnished back draft damper in duct work is sticking in partially closed position.
11. Dryer scraping noise at basket (tumbler) area.
1) Check for object caught in basket (tumbler) / wrapper area.
2) Basket (tumbler) is out of proper alignment.
a. Check both vertical alignment and lateral alignment.
b. Check gap between front panel and basket (tumbler)...set screws may have come
loose, and basket (nimbler) walked forward or back.
3) Loose basket (tumbler) tie rod.
4) Failed basket (tumbler) support.
12. Excessive noise and / or vibration.
1) Dryer is not leveled properly.
2) Impeller (fan / blower) is out of balance.
a. Excessive lint builds – up impeller (fan / blower).
b. Failed impeller (fan / blower).
3) Loose basket (tumbler) tie rod.
4) Baskets (tumbler) out of adjustment or adjustment bolts (hardware) are loose.
5) Failed basket (tumbler) support.
6) Loose motor mount.
7) Failed idler bearings or tumbler (basket) bearings.
8) V – Belts too loose or too tight.
7-8