Section 4: Operating And Programming Instructions; Operating Instructions - Image DE 30 Instruction Manual

OPERATING AND PROGRAMMING INSTRUCTIONS
OPERATING AND PROGRAMMING INSTRUCTIONS
A. OPERATING INSTRUCTIONS
NOTE: Before attempting to start the dryer make sure that the main door is closed and the
lint drawer is securely in place.
AUTOMATIC USUAL TUMBLE
1. Energize the electrical circuit to the tumbler at the disconnect switch or the circuit breaker.
The display is show "r101" about 3 second and then show P1 – P10.
2. Open the lint panel and check for any accumulated lint on lint screen. Close panel tightly
against tumbler frame and lock panel securely.
3. Open the cylinder door and load the cylinder with laundry. Overloading will result in
excessive drying time, wrinkled laundry, and wear to cylinder bearings.
4. Press "UP", "DOWN" button to select program P1 – P10.
5. Press "Start" button to run the machine the display is show countdown time.
The Dryer will start beginning with heating. When working completed time of in the
program. The heating system stops working. Then the cool down is working until completed time
the Dryer is stop
IMPORTANT: If the cylinder door is opened during the cycle, the heating system will shut – off
and the motor will stop. To restart the cycle, door must be closed and the PUSH
– TO – START button must be pressed in and held for approximately three
seconds.
6. When the cycle is completed, open door and remove the laundry.
SECTION 4
4-1