Preparation For Opertion / Start Up - Image DE 30 Instruction Manual

INSTALLATION PROCEDURES
I. PREPARATION FOR OPERTION / START UP
The following items should be checked before attempting to operate the dryer.
1. Read and follow all caution, warning, and direction labels attached to the dryer.
2. Check incoming supply voltage to be sure that it is the same as indicated on the dryer data
label located on the back of the dryer control (service) door
3. Check to assure that the dryer is connected to the type of heat / gas indicated on the dryer data
label (GAS MODELS ONLY).
4. The sail switch damper assembly is installed and pre – adjusted at the factory prior to dryer
shipment. However, the sail switch adjustment must be checked to assure that this important
safety control is functioning (GAS and ELECTRIC MODELS ONLY).
5. Check bolts nuts, screws, terminals, and fittings for tightness.
6. Be sure all gas shut – off valves are in the open position (GAS MODELS ONLY).
7. Be sure all back guard panels and service box covers have been replaced.
8. Make sure the lint coop support bracket has been removed.
9. Check the lint door to assure that it is closed and secured in place.
IMPORTANT: If during installation the lint door safety chain was disconnected, it must be
reconnected or personal injury may result.
10. Rotate the basket (tumbler) by hand to be sure it moves freely.
11. Check to insure all steam shut – off valves are open (STEAM MODELS ONLY).
12. Check to insure that a clean, dry, regulated air supply (80 Psi) is on the dryer (STEAM
MODELS with Damper System ONLY).
Figure.3-19 High pressure steams supply 125 psig Max
3-22