Electronic Control Instructions - HOMCOM A90-248 User Manual

4

ELECTRONIC CONTROL INSTRUCTIONS

4.1 Window display:
4.1.1 "SPEED":
The current speed value is displayed in the running state, and the speed display range is 1.0-12KM / H.
During the countdown, "3", "2", and "1" are displayed.
4.1.2 "TIME"
Displays exercise time. The display will count from 0:00 to a maximum of 99:59. Once the counter reaches the
selected time, the display will countdown to 0:00 from the set time, when the countdown reaches 0:00, the
treadmill will decrease speed slowly and come to a stop. Once the treadmill stops completely, it will enter
standby mode.
4.1.3 "DIS."
Displays the movement distance. The forward count will be from 0.0 - 99.9, and it will be re-counted after
overflow. The reverse count will decrease from the set value to zero. When the countdown reaches 0, the
treadmill will stop running at a steady speed and stop, and then enter the standby state after completely
stopping.
4.1.4 "CAL.":
Displays calories burnt value from 000-990 when counting forward, and recount after overflow, count down
from set value to 0 when counting backward, when the treadmill is down smoothly when counting down to
0. "PULSE" heart rate window:
4.1.5 "PULSE"
When a heart rate signal is detected, the heart-shaped icon flashes, and the pulse value is displayed. When
the treadmill is powered on, there is a heart rate display within 5 seconds of holding the heartbeat. The initial
value is the actual measurement.
4.2 Key functions:
4.2.1 "PROG" is the program selection key: In standby mode, press this key first to select the built-in programs
"P01-P02 -...- P12" in sequence-> Body fat test mode-> Manual mode->-.
4.2.2 "MODE" is the mode selection key: Press this key to cycle through "15:00", "1.0", "50.0" ("15:00" is the
time countdown mode, and "1.0" is the distance countdown mode, "50.0" is the calorie countdown
mode.) When selecting various modes, you can use the setting plus and minus keys to set the relevant
countdown value after completion, press the "START" key to start the treadmill.
4.2.3 "START" is the start key: When the power is on and the safety lock is engaged, press this key at any time
to start the running of the treadmill.
Treadmill A90-248 ~ 5 ~