Electronic Control Instructions - HOMCOM A90-250V70 User Manual

4

ELECTRONIC CONTROL INSTRUCTIONS

4.1 The appearance of the electronic watch is shown in the image below.
4.2 Start up.
Countdown starts after 3 seconds.
4.3 Number of programs
3 manual programs, 12 automatic programs, and 1 FAT program.
4.4 Safety lock function
When the safety lock is removed, the "E7" treadmill will quickly stop, and a beep alarm sound will appear. When
the safety lock is put on, the electronic watch will display for 2 seconds and all data will be cleared.
4.5 Button function
4.5.1 Start button, stop button:
Start button, when the treadmill is stopped, press the start button, the speed will display "1km" and the
treadmill will start. Stop button, when the treadmill is running, press the stop button, all data will be
cleared, the treadmill will return to manual mode after it stops, and the treadmill will stop.
4.5.2 Program button:
In the standby state, press this key to cycle from manual mode to automatic program P1-P12; manual
mode is the system default operating mode, the default speed of manual mode is 1km/h, and the
maximum operating speed is see function selection table.
4.5.3 Mode button:
When the treadmill is in standby, press the mode button to cycle through 3 different countdown
operation modes. Time, distance, and calorie countdown mode; when selecting various modes, you
can use the speed plus and minus keys to set the relevant countdown value, press start button after
setting the treadmill is started.
4.5.4 Speed plus and minus buttons:
It can be used to adjust the setting value when setting the parameters of the treadmill. After the
treadmill is started, it can be used to adjust the speed, with a step of 0.1Km/time, and automatically
continue to increase or decrease when the treadmill is held for more than 2 seconds. these two buttons
are included on the hand grip.
~ 5 ~