Preset Download - JVC DR-MH30B Instructions Manual

Filename [DR-MH30EU_04Name.fm]
DR-MH30EU_00.book Page 21 Thursday, June 3, 2004 11:00 AM

Preset Download

Auto Channel Set by Downloading from TV/Auto Clock
Set/Auto Guide Program Number Set
ATTENTION:
You can use this function only with a TV offering T-V Link, etc.* Be
sure to use a fully-wired 21-pin SCART cable.
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link or DATA LOGIC via a fully-wired 21-pin SCART
cable. The degree of compatibility and available functions may differ by
system.
ENTER
Page 21
If you have connected the unit to your TV via a 21-pin SCART
cable (
Download instead of the Auto Set Up in step 2 on page 20. After
downloading, the unit sets the clock and Guide Program numbers
automatically.
Slide the TV/CABLE/SAT/DVD switch to DVD.
1
Press 1 on the unit or DVD 1 on the remote control to turn on
the unit. The Country Set display appears on the TV screen. The
AUTO SET/T-V LINK display appears on the TV screen.
2
Press w e to select "T-V LINK"
and press ENTER. The T-V LINK
screen will appear.
ATTENTION:
CABLE/DBS
Preset positions on the front display
TV DVD
panel increase from "PR 1"; do NOT
press any button on the unit or remote
DVD1
control until the front display panel
shows clock time, "PR 1" or "– –:– –"
as illustrated on page 22.
When Preset Download is
completed, "COMPLETED"
appears for about 5 seconds, then
the normal screen appears.
If you press any button on the unit
or remote control while
we
downloading is in progress, it will
be interrupted.
NOTES:
For details, refer to the instruction manual of your TV.
In the area where no TV station transmits a PDC (Programme
Delivery Control) signal, the unit can perform neither Auto Clock Set
nor Auto Guide Program Number Set.
If there is a power cut, or if you press 1 or SET UP while
downloading or set up is in progress, it will be interrupted; be sure to
SET UP
turn off the unit power once and try again from the beginning.
Auto Clock Set may not function properly depending on the reception
condition.
On this unit, the characters available for station names (ID) are A–Z,
0–9, –,
may differ from those of your TV. (
After "Preset Download" is completed, perform "Monitor Set" on
page 24.
INITIAL SETTINGS
pg. 19), the unit will automatically perform Preset
INITIAL SET UP > AUTO CH SET
SET UP
EXIT
INITIAL SET UP > AUTO SET
SET UP
EXIT
, + and (space). Some names of downloaded stations
f I
pg. 74)
Thursday, 3 June 2004 10:46
Masterpage:Right+
21
EN
AUTO SET T-V LINK
TEST MODE
ENTER
SELECT WITH [ ] THEN PRESS [ENTER]
PRESS [SET UP] TO EXIT
SELECT
AUTO SET
PLEASE WAIT...
ENTER
SELECT WITH [ ] THEN PRESS [ENTER]
PRESS [SET UP] TO EXIT
SELECT