JVC DR-MH30B Instructions Manual page 80

Filename [DR-MH30EU_10Subsidiary.fm]
DR-MH30EU_00.book Page 80 Thursday, June 3, 2004 11:00 AM
TROUBLESHOOTING
80
EN
Recording (DVD Deck)
The desired programme cannot be recorded.
The channel position does not correspond to that in the
receiving area.
]Set the correct channel position for the receiving broadcast.
( pg. 72)
Recording cannot be made.
No disc or a disc not being compatible with the unit is loaded.
]Load a recordable disc on the unit. (
The disc loaded is not formatted.
]Format the disc. ( pg. 76)
A finalised DVD-R disc is loaded.
]Recording cannot be made on finalised discs. Load a recordable
disc on the unit.
The disc is full or does not have enough space for the title to be
recorded.
]Clear unnecessary titles on the disc or load a blank disc.
( pg. 53)
The DVD-RAM disc loaded has had its protect tab slid to the
protect position.
]Release the protect tab. ( pg. 9)
Recording (HDD Deck)
TV broadcasts cannot be recorded.
"L-1", "L-2" or "F-1" has been selected as the input mode.
]Set to the desired channel.
Camcorder recording is not possible.
The camcorder has not been properly connected.
]Confirm that the camcorder is properly connected.
The input mode is not correct.
]Set the input mode to "F-1". (
Page 80
pg. 6)
pg. 61)
Masterpage:Left+
Timer Recording
Timer programming cannot be made.
Date and time is not correct.
]Set date and time correctly. (
Timer recording is in progress.
]Timer programming can't be performed while a timer recording
is in progress. Wait until it finishes.
Timer programming recording does not start.
Date and time is not correct.
]Set date and time correctly. (
VIDEO Plus+ Timer Programming cannot be made.
Date and time set on the unit is not correct.
]Set date and time correctly. (
The channel position does not correspond to that in the
receiving area.
]Set the correct channel position for the receiving broadcast.
( pg. 72)
The VIDEO Plus+ system does not timer-record properly.
The unit's channel positions have been set incorrectly.
]Refer to "VIDEO Plus+ ® System Setup" (
perform the procedure.
Automatic Satellite Programme Recording does not start.
The satellite receiver is not connected properly to this unit.
]Connect the satellite receiver to the L-2 IN/DECODER
connector properly. ( pg. 50)
On the front display panel, "– –:– –" appears.
Power failure occurred.
]Set date and time correctly. (
"PROGRAMME FULL" appears on the TV screen during timer
programming.
32 programmes have already been timer programmed.
]Clear unnecessary programmes on the unit, then try timer
programming again. ( pg. 49)
The disc space does not increase when recorded titles are
cleared.
The PC's data recorded on a DVD-RAM drive cannot be cleared
on this unit.
]Format the disc. (When the disc is soiled, wipe the disc with a
soft dry cloth before formatting.) (
pg. 75)
pg. 75)
pg. 75)
pg. 72) and re-
pg. 75)
pg. 10, 76)
Thursday, 3 June 2004 10:46