Connecting To A Dolby Digital Decoder Or An Amplifier With Built-In Dts - JVC DR-MH30B Instructions Manual

Filename [DR-MH30EU_09Editing.fm]
DR-MH30EU_00.book Page 68 Thursday, June 3, 2004 11:00 AM
SYSTEM CONNECTIONS
68
EN
Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
These instructions enable you to connect your unit to a Dolby
Digital decoder or an amplifier with built-in DTS.
Dolby Digital Decoder or
amplifier with built-in DTS
To DIGITAL AUDIO input
Optical cable
(not provided)
Note for connection:
Remove the protection cap from the cable.
1
Connect the unit and a Dolby Digital decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.
NOTES:
For Dolby Digital sound, set "DIGITAL AUDIO OUT" to "DOLBY
DIGITAL/PCM". ( pg. 69)
For DTS sound, set "DIGITAL AUDIO OUT" to "STREAM/PCM".
( pg. 69)
CAUTIONS:
This unit has a dynamic range of more than 110 dB with regards to its
Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to the
speakers may damage them.
Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely affect
the playback picture.
Page 68
When you can't switch the audio channel of a bilingual
programme
When the unit is connected with a digital audio device using an
optional optical cable and "DIGITAL AUDIO OUT" is set to "DOLBY
DIGITAL/PCM", it is not possible to switch the audio channel of a
bilingual programme recorded on a DVD-RAM or DVD-RW (VR
mode) disc. In this case, perform the following steps using the
remote control to switch "DIGITAL AUDIO OUT" from "DOLBY
DIGITAL/PCM" to "PCM ONLY". (
A Press SET UP to access the Main Menu screen.
B Press w e to select "DVD VIDEO SET UP", then press ENTER.
C Press w e to select "AUDIO OUTPUT", then press ENTER.
D Press rt to select "DIGITAL AUDIO OUT", then press
ENTER.
E Press rt to select "PCM ONLY", then press ENTER.
(
F Press SET UP to complete the setting.
G Press AUDIO to select the desired audio channel.
Coaxial cable
(not provided)
DIGITAL OUT (COAXIAL)
DIGITAL OUT (OPTICAL)
pg. 69)
Masterpage:Left+
pg. 31)
Thursday, 3 June 2004 10:46