Figure 32 Removing the PCIe card
To install the PCIe card:
Open the PCIe latch.
1.
Remove PCIe card or blank.
2.
Push the PCIe card into riser card connector.
3.
Close PCIe latch.
4.
Install the screw.
5.
Figure 33 Installing the PCIe card
System Battery
The server uses nonvolatile memory that requires 4 batteries to retain system information when power
is removed.
This 3-volt lithium coin cell battery is located on the system board.
All manuals and user guides at all-guides.com
Removal and Replacement Procedures 51