On-board help
Tolerance table based on coupling format
For the same type of tolerance, RPM, and coupling diameter, the tolerances value differ
according to the coupling format selected. Coupling format (1) is gap/offset for short flex coup-
ling, and (2) is angle/offset for short flex coupling. Change coupling format by tapping 3.
Note
There are no tolerance tables for consolidated spacer shaft coupling formats. Con-
solidated formats consider the spoolpiece or jackshaft as an extension of either the
right or left shaft.
Suggested consolidated shaft alignment tolerances
The following table shows the consolidated (50 Hz and 60 Hz) tolerances
46
Version:2.3