Table of Contents
Advertisement
On-board help
on the round label affixed to the back of the sensor.
The sensor should be returned to an authorized PRÜFTECHNIK service center for cal-
ibration checking. You may contact your local PRÜFTECHNIK representative for assist-
ance or visit www.pruftechnik.com.
Note
The calibration due date is also found under "Sensor properties".
If the calibration due date has expired, the due date will be highlighted red.
The calibration due date will also appear on the asset measurement report if the "Gen-
erating report" menu item "Alignment measurement components " is activated.
114
Version:2.3
Advertisement
Table of Contents
