Table of Contents
Advertisement
On-board help
1: Quick release lever; 2: Horizontal angle adjustment knob; 3: 90° roof prism; 4: Vertical
position adjustment thumbwheel; 5: Measure mark = center of posts; 6: Support post (not
part of reflector); 7: Reflector dust cap
CAUTION
Avoid vigorous polishing to preserve the anti-reflective coating. Keep the dust cap on
the reflector when it is not in use.
Sensor and reflector labelling
Labels used in communicating laser safety and other general information are to be found
affixed to the housing of the system components.
(1)
The laser safety warning symbol label is affixed on the front of the sensor.
l
(2)
On the back of the sensALIGN 3 sensor is an amalgamation of three labels. The top
l
label shows the laser safety warning. The lower label contains the sensor identification,
related certification, and disposal information. The round calibration check label shows
the calibration check due date; the black arrow points to the month when the calibration
check is due. The year appears in center of the label. The following text is found on the
three labels:
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
P<1 mW, λ = 630-680 nm
IEC 60825-1:2014
Complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser
Notice No. 50, dated June 24, 2007
16
Version:2.3
Advertisement
Table of Contents
