Table of Contents
Advertisement
On-board help
Coupling properties
Swipe the carousel up or down and select desired coupling type.
The following coupling types are available for selection:
Short flex — These couplings feature fitted transmission elements with play (such as
l
teeth, claws or bolts) or elastic connecting elements like rubber 'tires' or springs.
Spacer shaft — When the coupling halves are joined by a spacer element, its length
l
must be entered.
Single plane — The coupling halves are bolted directly together. Loosen the bolts before
l
taking measurements, since they would otherwise distort the true alignment condition.
No coupling — This coupling format is intended for use with CNC machines. In this
l
format, the length between the two shafts must be entered.
Targets
Targets are misalignment values specified as an offset and an angle in two perpendicular
planes ( horizontal and vertical) and used to compensate for dynamic loads.
Access the coupling targets screen by tapping the item "Targets".
The displayed coupling format depends on the type of coupling selected.
To enter any target specifications at the coupling, tap the corresponding value box then pro-
ceed to enter the target value using the onscreen keyboard. Cycle through the value boxes
using
. Alternatively, tap the desired value box.
Target specification values are activated by tapping the icon
enabled, the coupling [2]within the mini train inset at the top-right corner appears in orange.
40
[1]. When target values are
Version:2.3
Advertisement
Table of Contents
