Panasonic AW-UE50WP Operating Instructions Manual page 87

Web screen configurations (continued)
z Pan/Tilt
„
The setting is confirmed with the [Set] button.
Install Position [Desktop, Hanging]
[Desktop] or [Hanging] is selected here as the method used to install
the unit.
Desktop Stand-alone installation
Hanging Suspended installation
Factory settings: Desktop
<NOTE>
• When [Hanging] has been selected, the top, bottom, left and right
of the images will be reversed, and up/down/left/right control for
panning and tilting will also be reversed.
P/T Speed Mode [Normal(60deg/s), Fast1(90deg/s),
Fast2(180deg/s)]
Set the speed of pan/tilt operation.
Normal(60deg/s) Pan/tilt operates at normal speed (maximum about
60° per second).
Fast1(90deg/s) Pan/tilt operates at fast speed1 (maximum about 90°
per second).
Fast2(180deg/s) Pan/tilt operates at fast speed2 (maximum about
180° per second).
Factory settings: Normal(60deg/s)
Speed With Zoom Position [Off, On]
[Off] or [On] is set here for the function used to adjust the pan-tilt
adjustment speed in conjunction with the zoom magnification.
When [On] is set, the panning and tilting operations will become
slower in the zoom status.
This function has no effect during preset operations.
Factory settings: On
Focus Adjust With PTZ. [Off, On]
[Off] or [On] is set here for the function which compensates for out-of-
focusing when it occurs during panning, tilting or zooming operations.
When [Off] is set, adjust the focus as required after zooming or set
[Focus Mode] to [Auto].
This is only enabled when [Manual] has been selected as the [Focus
Mode] setting.
Factory settings: Off
Privacy Mode [Off, On]
Sets Off/On the function for facing the camera to the rear when this
unit is switched to Standby mode.
Off Does not change the camera direction when the camera
is switched to Standby mode. (The camera remains in the
direction it was when the power was turned On)
On Moves the camera to face toward the rear when the
camera is switched to Standby mode.
Moves the camera to the position specified in [Power On
Position] when the power is turned On again.
Factory settings: Off
<NOTE>
• When [USB Auto Standby] is [On], this is grayed out.
Power On Position [Standby, Home, Preset]
Select the initial positions for Pan/Tilt/Zoom when the power is turned
on.
Standby Move to the Pan/Tilt/Zoom positions they were in the
last time the camera was switched to Standby mode.
Home Pan/Tilt move to their home positions (front) and
Zoom goes to the Wide end.
Preset Preset playback is performed at the preset position
specified with [Preset Number].
Factory settings: Standby
<NOTE>
• When [USB Auto Standby] is [On], this is grayed out.
Preset Number [Preset001 to Preset100]
Specify a number for preset playback when the power turns ON when
[Preset] is set in [Power On Position].
Factory settings: Preset001
<NOTE>
• If an unregistered preset number is set, preset playback is not
performed and the operation is the same as [Standby].
87