Parts And Their Functions; Camera Unit - Panasonic AW-UE50WP Operating Instructions Manual

Parts and their functions

Camera unit

5
8
Rear panel AW‑UE50
9 10 11
DC IN
LAN
12V
LINK ACT
SERVICE
14 15
Rear panel AW‑UE40
9 10 11
DC IN
LAN
12V
LINK ACT
SERVICE
14 15
Bottom panel
6
19
5 12 13
RS-422
3G SDI OUT
AUDIO IN
16 17 18
5 12 13
RS-422
AUDIO IN
17 18
1.
Mount bracket for installation surface (supplied
accessory)
Mount this bracket onto the installation surface, and then attach the
camera main unit to the bracket.
1
2.
Drop‑prevention wire
This wire is screwed down to the bottom panel of the camera main
unit. Loop the circle part of the wire around the hook of the mount
bracket.
3. Status display lamp
2
This lights in the following way depending on the status of the unit.
Orange Light up
3
Blink twice
Green Light up
Blink twice
4
Blinking
rapidly
6 Red Light up
Blinking
slowly
Blinking
rapidly
7
4.
Pan head
This rotates in the right and left direction.
5. Wireless remote control signal light‑sensing area
There are three light-sensing areas on the front and rear panels of the
camera pedestal.
6.
Hole for securing the camera pedestal
This hole is provided in the bottom panel of the camera pedestal.
7.
Camera head
This rotates in the up and down direction.
8.
Tally lamp
This comes on or goes off in response to the control from the
controller but only when "On" has been selected as the tally lamp use
setting. The tally lamp lights in three different colors; red, green, and
blue.
Red Light up
Blink once
Blink twice
Blink three
times
Green Light up
Blue Light up
16
When the standby status is established
When a signal not matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is on
When the power is on
When a signal matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is on
When the initialization process is complete
When trouble has occurred in the unit
Firmware being updated
When a PoE+ software authentication error has
occurred
When receiving a red tally signal
When a Pan/Tilt limit is set
When the Pan/Tilt limit is canceled
When start up of this unit is complete
When receiving a green tally signal
When USB Video Class/USB Audio Class is
operating