Selecting The Units - Panasonic AW-UE50WP Operating Instructions Manual

Selecting the units

Select the unit (or units) to be operated from the wireless remote control
or controller.
Even when using only one unit, it must still be selected.
When performing operations from a wireless
remote control
Up to four units can be operated using one wireless remote control.
To select this unit with the wireless remote control, set the [Wireless ID]
on the [System] screen from the OSD menu of this unit. (→ page 26)
1.
Press the CAMERA <1>, <2>, <3>, or <4> button.
The unit's status display lamp blinks green when a signal matched by
the remote control ID has been received, and it blinks orange when a
signal that is not matched by the remote control ID has been received.
When performing operations from a controller
A maximum of five units can be operated by one controller when using
serial control.
When using an AW‑RP150 or AW‑RP60
For details, refer to the operating instructions for the controller.
• Network connection with AW-RP150 or AW-RP60 requires setup of an
initial account. (→ page 28)
When an initial account is not set up, AW-RP150 or AW-RP60 can
detect but cannot control this unit.
32