Clearaudio Statement TT1 User Manual page 10

User manual
Now place the aligning gauge on top of the two round bases (see picture 6).
Rotate the round bases until all four pins on the bottom of the alignment gauge fit into the threads
machined into the bases.
Pic. 6: Placing the alignment gauge
While holding the alignment gauge in this position, tighten the two bolts with the hex wrench
provided (Pic. 7).
Attention:
TT1
Any misalignment at this stage will cause problems when positioning the tonearm
Pic. 7: Tightening the mounting bolts
After the round bases have been fixed, the alignment gauge can be removed.
Page 10 © clearaudio electronic GmbH, 2022-01