Table of Contents
Advertisement
2) Loosen the wiring screws on terminal board.
3) Insert the wire into the ring tongue terminal and tighten by crimping tool.
4) Use the screwdriver for tightening the terminal.
2.6.2 Connect Communication Wire of Wired Controller
(1)
Open electric box cover of indoor unit.
(2)
Let the communication wire go through the rubber ring.
(3)
Connect the communication wire to terminal H1 and H2 of indoor 4-bit wiring board.
(4)
Fix the communication wire with wire clip on the electric box.
(5)
Wiring instructions of remote receiving light board and wired controller:
2.6.3 Illuminate for Connection of Wired Controller and Indoor Units Network
(1) Communication wire of indoor unit and outdoor unit (or indoor unit) is connected to D1,
D2.
(2) Wired controller is connected to H1, H2.
(3) One indoor unit can connect two wired controllers that must be set as master one and
slave one.
3 Installation of Outdoor Unit
NOTES!
Graphics here are only for reference. Please refer to actual products. Unspecified
dimensions are all in mm.
Ducted Type Split Air-Conditioner Units(Inverter Series)
Fig.13
Fig.15
8
Unit: mm(inch)
Fig.14
Advertisement
Table of Contents
