Event Reporting And Acknowledgement - Notifier UniNet 2000 Simplex 4010 NION Installation And Operation Manual

Table of Contents

Mounting NION boards within

the enclosure

When installing single NION boards in

this enclosure, be sure to use the

inboard set of four mounting studs as

shown below.

NOTE: This enclosure must

contain power limited wiring only.

NOTE: Use only wire for power

limited systems. Power limited wire

runs use type FPLR, FPLP , FPL or

equivalent cabling per NEC 760.

2.3 Event Reporting and Acknowledgement

Event Reporting

The Simplex 4010 NION reports events to a UniNet™ 2000 workstation in the format LllDddd where ll is the loop

and ddd the device. The Simplex 4010 FACP has one loop capable of handling 250 devices. If, for example,

device 001 on loop 01 goes into alarm or trouble the UniNet™ 2000 workstation will display the device as

L01D001. Note that all event reporting of the Simplex 4010 NION is strictly ancillary.

Event Acknowledgement

All events of the Simplex 4010 must be acknowledged at the panel. Acknowledging an event from the UniNet™

2000 workstation will not acknowledge the event on the Simplex 4010 panel.

NOTE: The Simplex 4010 Panel reports all battery charger events as panel events.

NOTE: The Simplex 4010 panel supports custom labels for devices. These custom

labels are shown in the description field of the device at the workstation. However

the ampersand (&), star. (*), plus (+), pound (#), comma (,), apostrophe ('), caret

(^), and at (@) characters, if used in the custom label, will not be displayed in the

device description field at the workstation.

Technical Manuals Online! - http://www.tech-man.com

Mounting Studs w/Standoffs

Figure 2-5: Installing the NION in a NISCAB-1

Simplex 4010 NION Installation/Operation Manual Version 2 Document 51998 Rev. A1 03/26/03

firealarmresources.com

Simplex 4010 NION

Mounting Studs w/Standoffs

NISCAB-1

Table of Contents

Do you have a question about the UniNet 2000 Simplex 4010 NION and is the answer not in the manual?