Assembly Of The Pto Shaft - Tar River BDR-135 Operator's Manual

Drum mower
Hide thumbs Also See for BDR-135:
Table of Contents

Advertisement

IT IS UNACCEPTABLE
for any persons to be present between the machine and the tractor while backing up to the machine
to connect the machine while the tractor's engine is on and the key is in the ignition
to use parts to secure connections other than recommended by the machine or tractor manufacturers.
In order to connect the mower to the tractor:
1.
Insert the bottom push rods of the tractor (Drawing nr. 4, point 1) in the suspension frame pins (first the left one,
than the right one) and secure them with cotter pins (Drawing nr. 4, point 3).
2.
Slide the end of the upper connector between the yoke plates using the holes, then connect it with a bolt and se-
cure it with a cotter pin.
3.
Lift the mower to relieve the support (Drawing nr. 4, point 5
4.
Lift the support and support it with a cotter pin.
5.
Tighten the chain (Drawing nr. 4, point 4) that's limiting the side tilting of the tractor's suspension system.

Assembly of the PTO Shaft

The drum mower should be equipped with an efficient PTO shaft with a guard, safety sign or the CE marking as well
as the technical specifications in accordance with the technical guidelines.
Using a PTO shaft with parameters different than those recommended by the manufacturer of the machine may over-
load the shaft, damage it or result in pulling both parts apart while lifting the machine and so create hazard for the
operators and the environment.
While assembling the PTO shaft, you should make sure, that the external pipe of the cover is on the side of the trac-
tor.
Tractor
Ci¹ gnik
In order to install the shaft:
Lower the mower down to the ground, turn off the engine and take out the key from the ignition.
Insert the female tube end yoke to the power input of the machine and the power take-off of the tractor
and secure it from sliding out with rivets.
Check whether the rivets secure the ends of the shaft from sliding out during operation.
Install the chains of the shaft cover; one to the cover of the tractor's power take-off, and the other to
the cover of the machine's power input.
WARNING using a damaged PTO shaft, without the cover or a damaged cover , and without the ad-
ditional cover on the side of the tractor's power take-off and the machine's power input creates immediate
hazard of an accident.
Mower
Kosiarka
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bdr-165Bdr-185

Table of Contents