Table of Contents
Advertisement
HYDROK
Safety
Moving parts
Stroke
Insufficient workpiece
clamping
Insufficient workpiece
clamping
18
WARNING
Serious injuries caused by touching rotating
and/or moving parts!
Do not open guards while the system is operating.
During operation, do not reach for rotating and/or
moving parts.
Pay attention to the gap dimensions of moving
parts.
Before opening the guards, ensure that none of
the parts are moving any more.
WARNING
Serious crushing injuries caused by the stroke of
the product!
Never reach into an area where moving parts are
operating.
Prevent accidental initiation of the clamping pro-
cess [for example due to an installation error with
the power supply or a programming error].
DANGER
Serious injuries caused by parts being ejected
centrifugally if level of workpiece clamping is in-
sufficient!
Workpiece blanks must not be outside the clamp-
ing width diameter.
Clamping of the workpiece must not be outside
the defined limits [see »Limits of use« chapter].
Do not exceed the maximum performance values
[see »General information« chapter].
WARNING
Serious injuries caused by breakage of individual
components of the product when supply pressure
is too high!
Check supply pressure on a regular basis and ad-
just if necessary.
Order hotline +49 7144.907-333
Advertisement
Table of Contents
