Default Settings (Original Factory Settings) - COMAC CAL FLOW 38Imp Batch Manual

Default settings (original factory settings)

During activation of this function, the configuration of the meter will be restored to the factory default
state in which it was shipped. All user settings will be deleted and if the metrology jumper J1 on the
power supply board is connected (non-certified meter used for non-billing purposes), all volumetric
counters will be reset as well.
The user password is cancelled and the access code is reset to original (0000).
This applies to calibration of the meter as well. Before activating this function, it is useful to record or
make a backup of the data of all counters.
This function can be activated without the access code!
If you wish to apply the original factory settings, press E and use the  or  button to select YES from
menu and then confirm by E.
After confirmation of the change, the meter will have the settings it had when it was delivered by the
manufacturer.
Technical and installation
manual FLOW 38 Batch (impulse) Page 23 (total 26) COMAC CAL s.r.o.