Batteries And Power; Storage Recommendations - DeWalt DCE074R Original Instructions Manual

EnGLIsH

WARNING! DO NOT DISASSEMBLE THE LASER. There
are no user serviceable parts inside. Disassembling
the laser will void all warranties on the product. Do
not modify the product in any way. Modifying the tool
may result in hazardous laser radiation exposure.

WARNING: Fire hazard ! Avoid short-circuiting the
contacts of a removed battery.
Additional Safety Instructions for Lasers
• This laser complies with class 2 according to IEC/EN 60825-
1:2014. Do not replace a laser diode with a different type.
If damaged, have the laser repaired by an authorised
repair agent.
• Do not use the laser for any purpose other than projecting
laser lines.
• An exposure of the eye to the beam of a class 2 laser is
considered safe for a maximum of 0.25 seconds. Eyelid reflexes
will normally provide adequate protection.
• Never look into the laser beam directly and intentionally.
• Do not use optical tools to view the laser beam.
• Do not set up the tool at a position where the laser beam can
cross any person at head height.
• Do not let children come in contact with the laser.
Residual Risks
The following risks are inherent to the use of this device:
• injuries caused by staring into laser beam.
Labels on tool
The following pictographs are shown on the tool:
Read the instruction manual before use.
Laser warning.
28
Do not stare into the laser beam.
Date Code Position
The date code, which also includes the year of manufacture, is
printed into the housing.
Example:
Year of Manufacture
Important Safety Instructions for All Battery
Packs
When ordering replacement battery packs, be sure to include
catalog number and voltage. Consult the chart at the end of this
manual for compatibility of chargers and battery packs.
The battery pack is not fully charged out of the carton. Before
using the battery pack and charger, read the safety instructions
below. Then follow charging procedures outlined.
READ ALL INSTRUCTIONS

Batteries and Power

• This D WALT rotary laser will accept all D
e
lithium ion batteries, but is built to best resist damage
during a fall when used with the following batteries: All
1.5Ah & 2Ah D WALT 18 volt lithium ion batteries.
e
• Consult the chart at the end of this manual for compatibility
of chargers and battery packs.
• Refer to Battery Safety Manual for safety instructions.
Battery Installation / Removal and
Charging
To install battery pack (Fig. a)
Using the 18V D WALT Rechargeable Pack:
e
• Install the 18V D WALT Rechargeable Battery pack as shown
e
in Figure A.
1. Depress the battery release button
2. Slide the battery pack into the track firmly.
3. Release the battery release button on the battery.
To Remove the battery pack
1. Depress the battery release button on the battery.
2. Slide the battery pack out of the track
3. Release the battery release button on the battery.
4. To recharge the battery pack, insert it into the charger as
described in the Battery Safety Manual.

WARNING: Batteries can explode, or leak, and can cause
injury or fire. To reduce this risk. Refer to Battery safety
Manual for safety instructions.

Storage Recommendations

1. The best storage place is one that is cool and dry, away from
direct sunlight and excess heat or cold.
2. Long storage will not harm the battery pack or charger.
Under proper conditions, they can be stored for 5 years
or more.
2016 XX XX
WALT 18 volt
e
14 on the battery.