Advertisement

anovafurnishings.com
888.535.5005 tel

tools needed

• 
9/16" Open-end or Box-end Wrench
• 
Ratchet with 9/16" Socket

Assembly HArdwAre:

8 x
8 x
3/8"
3/8" X 1.5"
Hex Head Bolt
Hex Nut

Assembly:

NOTE: Before assembling the Nuts to the Bolts, it is recommended that a light oil or petroleum jelly be applied to the Bolt threads.
1. Inspect the shipping container contents for damage and to determine that all components and hardware are present.
2. Place the Inner Rack on the packaging cardboard or other soft surface. Position one of the Rack Ends near one end of the Inner
Rack.
3. Align the mounting holes in the bracket on the Rack End underneath the mounting holes at the end of the Inner Rack. Install a
Flat Washer onto one of the 1.5" long Bolts and insert the Bolt through both parts, with the Bolt head on the top surface of the
Inner Rack. Install a Washer and Hex Nut on the end of the Bolt.
Leave the hardware finger tight so that adjustments can be made.
Install a Bolt and Washer through the other set of mounting holes in that end of the Inner Rack and Rack End bracket and
install a Washer and Nut. Tighten the hardware.
Assembly InstructIons
brP101
Loop Bike Rack
brP102
Hoop Bike Rack
16 x
3/8"
Flat Washer
Packaging cardboard
or other soft surface
bencH comPonents:
2 x
Rack End
Inner Rack
(Hoops or Loops)
Inner Rack
Flat Washer
Nut
Model BRP101 shown.
Inner Rack design may vary.
OR
1 x
1.5" Long Bolt
and Flat Washer
Flat Washer
and Nut
Hex Head Bolt
Flat Washer
Rack End

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BRP101 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Anova BRP101

  • Page 1 Assembly InstructIons brP101 Loop Bike Rack brP102 Hoop Bike Rack Model BRP101 shown. anovafurnishings.com Inner Rack design may vary. 888.535.5005 tel tools needed bencH comPonents: •  9/16” Open-end or Box-end Wrench •  Ratchet with 9/16” Socket Assembly HArdwAre: 16 x 3/8”...
  • Page 2 4. Attach the other Rack End to the other end of the Inner Rack in the same manner, installing the 1.5” long Bolts from the top. Tighten the hardware after both Bolts are installed. 5. Retighten all hardware two weeks after initial assembly. Packaging cardboard or other soft surface Flat Washer...

This manual is also suitable for:

Brp102

Table of Contents