Anova Perforated Steel Café Chair D1145 Assembly Instructions

anovafurnishings.com
888.535.5005 tel

TOOLS NEEDED:

• Rubber mallet
• Flat head screwdriver
• Ratchet with 1/2" socket
• Level

CHAIR COMPONENTS:

(1) Contour Seat
ASSEMBLY HARDWARE: All hardware is stainless steel.
(6) 5/16"-18 x 2"
Slotted Screws
ASSEMBLY:
1. Inspect the shipping container contents for damage and to
determine that all components and hardware are present.
2. Assemble the chair over the shipping packaging or padded
work area to avoid scratching the product.
NOTE: Before assembling the nuts to the bolts, it is
recommended that a light oil or petroleum jelly be applied
to the screw threads.
3. Locate the contour seat and place it on the work surface as
shown.
Align one of the spacers on the edge of the seat so the
mounting holes line up.
Align one of the supports over the spacer so the mounting
holes line up. Then insert three 2" screws through all three
parts with the screw head on the outside of the chair. Place
a flat washer and nylock nut on the end of each screw and
tighten finger tight.
NOTE: Installing the screw in this direction reduces the
risk of scratching during use.
Assembly Instructions
Streetside Square Café Chairs
D1145 - Perforated Steel Café Chair
F1145 - Expanded Steel Café Chair
Streetside Perforated Steel
Café Chair
(2) Seat Supports
(6) 5/16"-18 (6) 5/16" Flat Washers
Nylock Nuts
Streetside Expanded Steel
(2) Spacers
(4) Foot
Seat Support
Café Chair
5/16"-18 x 2"
Slotted Screw
Spacer
5/16" Flat Washer
5/16"-18
Nylock Nut
Contour Seat
1