Advertisement
Quick Links
(800) 231-1327
specify@anovafurnishings.com
anovafurnishings.com
Assembly Instructions
Madison 6' Contour Benches
RCPMC6 - 6' Recycled Plastic Bench
THMC6 - 6' Thermory® Bench
Tools Needed
1/2' Open-end or Box-end Wrench
Ratchet with 1/2" Socket
18 Volt (or higher) Drill with No. 3 Phillips bit
and extension
Level
Square
Component Parts
Hardware Needed
Nyloc Hex Nut
Assembly Instructions - This is a two-person operation.
1. Inspect the shipping container contents for damaged or missing components.
2. Lay all parts on a soft work surface or one the shipping packaging to prevent damage to finish.
NOTE: Before assembly, it is recommended that a light oil or petroleum jelly be applied to any threads.
© 2019 ANOVA®
MAy-2024
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Anova Madison RCPMC6
Summary of Contents for Anova Madison RCPMC6
- Page 1 2. Lay all parts on a soft work surface or one the shipping packaging to prevent damage to finish. NOTE: Before assembly, it is recommended that a light oil or petroleum jelly be applied to any threads. © 2019 ANOVA® MAy-2024...
- Page 2 4. Repeat this for the other bench end. Leave the hardware loose enough that adjustments can be made. In order to clarify the order of assembling the planks, refer to this diagram for the plank location number. © 2019 ANOVA® MAy-2024...
- Page 3 Fasten the plank to the bench ends using two No. 12 Phillips head screws through the mounting holes on each bench end. Note: It may be easier to tip the bench onto it’s backrest to attach the seat planks. © 2024 ANOVA MAy-2024...
- Page 4 10. Install planks into the number 4 and number 5 plank locations. Make sure the ends of the planks are flush with the outside of the bench ends. Fasten the ends of the planks to the bench ends using No. 12 Phillip head screws. © 2024 ANOVA MAy-2024...
- Page 5 12. Install No. 12 Phillips head screws through the supports and into the planks in the number 2,3,and 4 plank locations and tighten them down. 13. Tip the bench back onto it’s backrest in order to install the screws into the seat planks. © 2024 ANOVA MAy-2024...
-
Page 6: Care And Maintenance
This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to remove surface dirt. • Do not clean with a solvent or petroleum based products. Manufactured in the U.S. © 2019 ANOVA® MAy-2024...
Need help?
Do you have a question about the Madison RCPMC6 and is the answer not in the manual?
Questions and answers