Advertisement
16
Troubleshooting
Symptom
"6" blinks while the cooked food is
kept warm.
"24" blinks on the display when the
[Hr] key is pressed while the Keep
Warm function is on.
"0:00" blinks on the display when the
power plug is connected.
The lid does not close or opens
during cooking.
The lid does not close.
Condensation collects in the upper
casing.
Nothing happens when a key is
pressed.
The power plug sparks.
There is a smell of plastic.
There are stripes or waves on the
plastic parts.
The clearance between the lid and
rice cooker becomes larger during
cooking.
"
" appears on the display.
46
46
46
シンガポール・香港向け
Check point
Was the Keep Warm function used continuously for more than 6 hours
after cooking?
After 6 hours has elapsed, "6" blinks on the display. (Do not keep warm for
more than 6 hours after cooking.)
Was the Keep Warm function used continuously for more than 24 hours?
After 24 hours has elapsed, "24" blinks on the display.
Are the current time and preset timer
settings and elapsed Keep Warm
time lost when the power plug is
connected again?
Were the [Cancel] key and [Timer]
key pressed at the same time?
Are there any grains of rice adhering
to the upper casing, inner lid gasket,
or around the hook catch?
Is the inner lid set in place?
Is the lid closed just after the cooked
rice is loosened?
Condensation may collect in the upper casing immediately after rice is
cooked or while the Keep Warm function is on but it is not a malfunction.
Wipe the upper casing using a dry cloth when condensation collects.
Is the inner lid dirty?
More condensation can be formed
on the dirty inner lid.
Is "Eco" selected?
When using the "Eco" menu, more condensation may be formed on the
inner lid.
If condensation becomes an issue, it is recommended to use the "Plain"
menu.
Is the appliance plug properly
connected to the appliance plug inlet
of the rice cooker and the power
plug connected to an outlet?
Is the Keep Warm lamp on?
A tiny spark specific to the induction heating method may occur when the
power plug is connected or disconnected, however, it is not a malfunction.
Such smells may occur when the rice cooker is first used, however,
they should go away over time. If this is an issue, clean the rice cooker
according to "Cleaning".
Such stripes and waves are produced when the resin is being molded.
They do not affect the performance of the rice cooker.
Pressure is applied during cooking and the lid is lifted. The clearance
between the lid and rice cooker may become larger, however, the
performance of the rice cooker is not affected.
When the [Cancel] key is pressed,
the following appears on the display.
Action
Normal cooking can be performed
even when the lithium battery has
run out. To replace the battery,
contact the place of purchase for a
repair service.
Set the right time.
Completely remove all remaining
rice.
Set the inner lid.
The inner lid of the pressure rice
cooker is highly air-tight. The lid may
be slightly hard to close but it is not
a malfunction. Close the lid slowly.
Thoroughly clean the inner lid using
a detergent.
Securely insert the plugs.
Press the [Cancel] key to turn off the
Keep Warm function and then try the
operation again.
The rice cooker is in the demo
mode.
Contact the place of purchase for a
repair service.
Reference
page
30
26
11
56
17,
34 to
37
38
20
20
36
12
17,22,
24,29
17
-
41
-
-
-
Advertisement
Chapters
