Download Print this page

Tiger JPT-H10S Operating Instructions Manual page 23

Pressure induction heating rice cooker/warmer

Advertisement

6
Press the [Timer] key to select
either "Timer 1" or "Timer 2".
The selected setting switches between "Timer
1", "Timer 2", and "Soak Timer" each time the
[Timer] key is pressed.
• For the Soak Timer function, see P.24.
The previous preset
time is displayed.
On
Blinks
Blinks
• The previously preset time is displayed. It
is not necessary to set the timer again if the
desired completion time is already displayed.
Note
● The Timer function is not available in the following
cases.
• When the "Quick", "Express Limited cups",
"Sweet", "Mixed", "Slow Cook", "Cake", or "Clean
care" menu is selected
• When "0:00" is blinking on the display
• When the inner pot is not set
● If the Keep Warm lamp is on, press the [Cancel]
key to turn off the lamp. (The Timer function is not
available while the Keep Warm lamp is lit.)
● Dark brown crisp rice may be formed when the
timer setting is extended. If this is an issue, rinse
the rice or barley well.
Timer setting guidelines for each menu
Menu
Timer setting guideline
Eco
1 hr. 5 min. or more
Plain
1 hr. 5 min. or more
Ultra
1 hr. 20 min. or more
Long-grain
45 min. or more
Porridge
Cooking time + 1 min. or more
Multigrain
1 hr. 10 min. or more
Brown
1 hr. 25 min. or more
Brown GABA
4 hr. 35 min. or more
Sushi
55 min. or more
• When the preset time is less than the timer
setting guideline, cooking may not be completed
at the preset time.
„ Sounds emitted by the rice cooker
● If you do not operate the rice cooker within
● If the [Timer] key is pressed while the rice cooker is in
● If the sound becomes bothersome, the volume
7
Short
beep
● Do not set the timer to more than 12 hours, as it
8
approximately 30 seconds after pressing the [Timer]
key, the rice cooker beeps 2 times (short beeps).
a state where the Timer function is not available, the
rice cooker beeps 2 times (short beeps).
can be adjusted. (See P.49)
Press the [Hr] and [M] keys to set
the desired completion time.
• The current time is displayed in a 24-hour
format.
On
Blinks
Short
beep
Blinks
• Press the [Hr] key to change the set time
in increments of 1 hour. Press the [M] key
to change that time in increments of 10
minutes.
• Hold down the corresponding key to change
the time more rapidly.
Note
may result in spoiled rice.
Press the [Start] key once.
The Timer function is set.
On
For "Plain" menu
Short and
long beep
For other menus
Long
beep
On
On
• If you make a mistake or otherwise want to
reset the timer, press the [Cancel] key and
repeat the procedure from step
シンガポール・香港向け
3
on P.22.
23

Advertisement

loading

This manual is also suitable for:

Jpt-h18s