Intended Use; Operation - Worx WG259E Original Instructions Manual

And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimize your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Avoid using tools in temperatures of 10
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
WG259E
Blade
1
sheath
10
Safety
1
guard
Charger 1 (WA3760)
Battery 1
pack (WA3551.1)
WG260E
Blade
sheath
Safety
guard
Charger 1 (WA3760)
Battery
1 (WA3551)
pack
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
Cordless Hedge Trimmer
0
C or less.
WG259E.5 WG259E.9
1
1
1 (WA3860)
1
(WA3551.1)
WG260E.9
1 1
1 1
/
/
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The machine is intended for cutting and trimming
hedges and bushes in domestic use.
WARNING! Do not use the product
without attaching the guard and front
handle.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the safe guard
Assembling the Front Handle
NOTE: Handle screws should be facing
the protective shield. If the handle is
assembled incorrectly, the tool will not
power on.
Installing and Removing the battery pack See Fig. C
Charging the battery pack
Your battery pack is UNCHARGED, you
must charge before use.
1
More details can be found in WA3760 (for
WG259E/WG260E) or WA3860
1
(for WG259E.5) manual

OPERATION

/
Starting and stopping
/
Top cutting
WARNING: If any parts are
missing, damaged or broken, do
not operate your hedge trimmer until
all damaged parts have been replaced
or repaired. Failure to do so could result
in serious personal injury. DO NOT
USE WITHOUT FRONT HANDLE AND
SAFETY GUARD.
Side cutting
Lubricating the Cutting Blade
NOTE: It is important to use only the
recommended standard lubricating oil
(WD-40) to avoid damage to the blade.
FIGURE
See Fig. A
See Fig.
B1, B2, B3
See Fig.
D1, D2
See Fig.
E1
See Fig.
E2
See Fig. F
EN